Before installing the App, please read the details below as this contains important information about the App.
Connect to Premier 48 - 168, Premier Elite 12 - 640 and Premier International 412 - 832 control panels using your Android Phone or Tablet.
The App requires a ComIP, ComWIFI, ComGSM or Chiron IRIS module connected to a Premier or Premier Elite control panel *
Access your system from the keypad as if you were using a real keypad. New Basic Portrait Keypad available.
Smartkey / Basic Arming
Allows you to arm, part arm, disarm and reset you alarm system. It also allows you to activate up to 3 outputs (control panel dependent) which can be used to control lighting etc. If 'Basic Arming' is enabled, you will be able to activate up to 8 outputs (control panel dependent).
Allows you activate up to 8 X10 devices (control panel dependent) which can be used to control lighting etc.
View the last 25 log events.
Add and delete up to 9 pre-defined site profiles.
Select which screen the App starts on, Menu, Smartkey or Keypad.
Push and Email Notifications *
Receive information from your panel regarding its status via push notifications or email. Registration for the service is required.
View and record up to 4 IP cameras. Includes PTZ controls.
User Name: Master
Terms and Conditions
The Keypad App (the App) allows you to exercise basic control and run diagnostics of your alarm system including, but not limited to, arming, part arming, disarming and resetting your alarm system. These terms and conditions relate to the App and govern your use of the App with Texecom Limited (Us, Our, We, or Texecom). Details of these terms and conditions can be found at http://www.texe.com/Disclaimer_MobileApps_Android.pdf. By downloading the App you agree to be bound by these terms and conditions.
To ensure the very best user experience, please make sure your control panel has the latest firmware.
* Push notifications can only be send using Texecom communicator modules.
Fixed issue with outputs / arming screen after editing text.
Added Alert to log.
Added progress bar to log.
Fixed update IP for Cameras.
Fixed issue with Update IP address when address was null.
Fixed Issue with protected UDL.
Improvements to internet access checks and warnings.
Added checks for invalid port numbers.
Added checks for spaces and invalid port numbers in Cameras details.