Boat & Marine Engine Toolkit is a professional calculator suite for boat owners, marine engineers, naval architects, ship captains, and offshore platform crews. Run every calculation fully offline — at the dock, at anchor, or miles from the nearest cell tower. No ads, no accounts, no subscription.
From sizing ground tackle for a blow to checking prop shaft torque before sea trials, the toolkit puts trusted marine engineering formulas in your pocket and keeps them there.
WHAT'S INCLUDED:
Fuel Burn & Range, Bollard Spacing, and the CG-719S reference are free. The other six calculators and five reference tables open with the one-time unlock below.
Navigation & Anchoring
- Hull Speed Calculator — compute theoretical hull speed and speed/length (S/L) ratio from waterline length for sailboats, trawlers, and displacement craft.
- Anchor Rode Scope — plan rode length from water depth, bow height, and tide for safe overnight holding.
- Concrete Anchor — allowable tension and shear for dock and pier fittings bolted into concrete, from anchor type, bolt diameter, embed depth, concrete f'c, and edge distance (ACI 318-19 Ch. 17).
Propulsion & Drivetrain
- Prop Shaft Torque — calculate shaft torque from engine horsepower and shaft RPM for gearbox and coupling sizing.
- Hydraulic Cylinder Force — push and pull force from bore, rod diameter, and system pressure for steering, hatch, and deck gear.
- Fuel Burn & Range — project burn rate in GPH, cruising range in nautical miles, and fuel cost per hour from engine power, engine load, tank capacity, and cruise speed in knots.
Safety & Compliance
- Bilge Pump Sizer — size pump capacity against hull volume with ABYC-aware guidance for peace of mind.
- Bollard Spacing — lay out vehicle-barrier bollards to ASTM F2656 K4/K8/K12: bollard count, maximum on-center spacing, and impact energy and force from vehicle weight, speed, and protected width.
Reference Tables
- Beaufort wind scale, anchor type comparison, ABYC bilge pump standards, shaft material properties, hydraulic cylinder sizes, and CG-719S return reasons — the numbers you actually reach for on deck.
WHO IS IT FOR:
- Boat owners planning passages, provisioning, and ground tackle
- Marine engineers sizing drivetrains, hydraulics, and auxiliaries
- Naval architects sanity-checking hull displacement and S/L figures
- Ship captains and mates running quick bridge calculations
- Offshore platform crews and workboat operators on deck
- Marine surveyors documenting condition and compliance notes
WHY MARINE PROS LOVE IT:
- 100% offline — every calculator runs on-device, so you never lose a tool when you lose signal offshore.
- No ads and no tracking — clean, focused screens built for use at sea.
- No subscription — pay once, own it, use it on every trip.
- Instant results — type values, get answers, move on to the next job on the checklist.
- Professional formulas — ABYC-aware guidance, standard naval architecture equations, and clear unit handling (knots, feet, inches, psi, bar, gallons, HP).
ONE-TIME UNLOCK:
Unlock All Calculators is a single $12.99 USD in-app purchase. It is a one-time, non-consumable unlock — not a subscription. One payment opens every Pro calculator and every reference table, forever, on your Apple ID. Prop pitch planning, shaft torque, bilge pump sizing, hydraulic cylinder force, Beaufort references — all in.
Stow it in your pocket, keep it on the bridge, or pin it to the engine room iPad. Boat & Marine Engine Toolkit is built to be the quick, quiet answer to the everyday marine engine and offshore questions that keep boats running and crews safe.
Show more
Show less
